Changing a Manual Valve for a Thermostatic Radiator Valve

Changing a Manual Valve for a Thermostatic Radiator Valve
16 November 2023 506 view(s) 2 min read
Changing a Manual Valve for a Thermostatic Radiator Valve

It is relatively straightforward for a professional to swap a manual valve for a TRV and it is recommended that all radiators in the house are upgraded at the same time. This should be completed by a professional as it is important that the inhibitor in the system is properly checked and topped up if necessary. The system will also need to be rebalanced to ensure optimum performance.

A simplified version of the process is as follows: 

  1. Drain the heating system. As the valves have to be removed fully, they cannot be used to isolate the radiator in question.
  2. Once the system is empty, the nuts and compression fitting that connects the valve to the radiator and system pipework can then be loosened and the valve removed from the pipe.
  3. Remove the existing valve insert from the radiator connection. The new TRV will be supplied with an insert that is fully compatible with the new valve. This can be done with a hex tool and spanner.
  4. The new valve insert can then be fitted in its place.
  5. Push the new valve housing onto the pipework and tighten the fitting. Repeat with the connection to the radiator
  6. Fit the TRV head unit onto the valve body and adjust it to the required setting.
  7. Repeat the process with the lockshield valve.
Previous article:
Next article: